Network Settings

Converting Verizon ONT coax connection (MoCa) to Ethernet (Cat6). Note: LEAVE the OLD Coax cable plugged into the ONT and connected to the Verizon   Router so customer will get Video and demand on their cable boxes (if Tivo Cable box...

These are the instructions on how to configure a U-verse gateway to send all of its incoming traffic to your own router without impacting its normal networking services. i.e:  Using it as a modem only. The gateway : The gateway c...

A DHCP Range is a range   of IP addresses from which to include or exclude addresses used for DHCP  service  lease offerings. Basically, when network devices that are DHCP are connected to the network, they receive a temporary address in the DH...

A Port Forward  is a communication path that allows outside clients to access Local network devices from off-site.  This is commonly performed to view surveillance cameras off-site or to control a Total Control system from off-site. This article o...

Total Control is extremely reliant on the network, both hard-wired as well as wireless. Below are the most important configurations for Wi-Fi when installing a TC system. URC's Wifi remotes communicate on 802.11 B/G/N however we o...

Discovering & Assigning URC Devices and Assigning IP Address for 3 rd Party Devices All Network devices in a Total Control System must have a known IP address .  URC devices are discovered and assigned through the software.  3rd Party...

A problem was identified with Arris/Cisco routers.  The issue was causing connection and discovering issues with the TRC-1080s.  There was a firmware update in May 2015 that rectified this problem. The TRC-1080 must be on the latest fir...

PC Network Settings in Total Control  (Network Troubleshooting, Can't Discover Devices, Failed to Download) Total Control is reliant on the network and requires a reliable, stable and properly configured network. Programming a Total Control sys...